A Comparative Study of Performances Between the WDM PON System and the CWDM PON System in an Optical Access Network

Abstract

Abstract The growth of optical technology is currently being studied extensively to meet the significant demand for bandwidth. The passive optical network (PON) solves the problem of bandwidth as it extends the optical network to individuals and businesses [Sifta R, Munster P, Krajsa O, Filka M, “Simulation of bidirectional traffic in WDM-PON networks", Brno University of Technology, ISSN 0033–2097, R. 90 NR 1/2014.]. In this paper, a comparative study is made between the WDM PON system and the CWDM PON system using two different architectures, one for the WDM PON and the other for the CWDM PON, to illustrate the appropriate technique for the PON network by increasing the Q factor and the OSNR ratio while minimizing the bit error rate (BER < 10–9 ). Both systems are simulated at 10 Gbps for four users of bidirectional SMF (Single Mode Fiber) fiber lengths and different powers. In order to determine the transmission performance for both systems, the link was designed for fiber lengths of 20, 30, 40, 50 and 60 km as well as for powers from −10 dBm up to 10 dBm for four users. The use of the EDFA amplifier in the WDM PON system is required in this document to minimize degradation caused by attenuation [Parkirti RDK, Singh R. Cost-efficient Colorless WDM-PON Based on RSOA for High Capacity. Int J Adv Res Comput Eng Technol (IJARCET). 2016;5]. On the contrary, in the CWDM PON system, the amplification is not essential because the wavelengths used in this system are not affected by the water peak which causes a strong attenuation of the wavelengths in the 1370–1410 nm range on optical fibers [Nazir M, Arshad F, Asif R. Design and evaluation of power budget for a bidirectional CWDM-Passive Optical Network. In: International Conference on Communication, Computing and Digital Systems (C-CODE), Islamabad, Pakistan, 04 May 2017.]. The peak of water vapor absorption is close to 1383 nm.