Free vibration analyses of 3D printed plates with different geometric fillings: experimental testing and numerical simulations-Reference-Cited by-同舟云学术

Free vibration analyses of 3D printed plates with different geometric fillings: experimental testing and numerical simulations

Published:2024-09-03 Issue: Volume: Page:
ISSN:0932-0784
Container-title:Zeitschrift für Naturforschung A
language:en
Short-container-title:

Author:

Yildiz Ahmet¹,İbram Emre²,Erol Onur²,Güler Özgül Hande²

Affiliation:

1. Mechanical Engineering Department , 37523 Bursa Uludag University , Bursa , Türkiye

2. Automotive Engineering Department , 37523 Bursa Uludag University , Bursa , Türkiye

Abstract

Abstract In this article, the numerical and experimental free vibration analyses of PLA-based composite plates with different filling geometries were carried out. Firstly, the natural frequencies and modal shapes were obtained from finite element (FE) methods to characterize the vibration behavior of the plates. The obtained results were compared with experimental testing of the three-dimensional (3D) produced plates. In the comparison, it was seen that the finite element analysis and the experimental results were quite close to each other. It was also observed that the highest frequencies are measured by a triangle, then the grid and honeycomb. Moreover, higher frequencies and lower weights are possible with the triangle pattern fill. On the other hand, it is noted that the types of filling structures do not affect the modal shapes of the 3D plates. Thus, the results of this paper are of utmost importance for getting light structure and high frequencies.

Publisher

Walter de Gruyter GmbH

Link

https://www.degruyter.com/document/doi/10.1515/zna-2024-0062/pdf

Reference28 articles.

1. H. Saniei and S. Mousavi, “Surface modification of PLA 3D-printed implants by electrospinning with enhanced bioactivity and cell affinity,” Polymer, vol. 196, no. 5, 2020, Art. no. 122467. https://doi.org/10.1016/j.polymer.

2. D. Wu, A. Spanou, A. Diez-Escudero, and C. Persson, “3D-printed PLA/HA composite structures as synthetic trabecular bone: a feasibility study using fused deposition modelling,” J. Mech. Behav. Biomed. Mater., vol. 103, no. 3, 2020, Art. no. 103608. https://doi.org/10.1016/j.jmbbm.2019.103608.

3. V. Martin, et al.., “Engineering a multifunctional 3D-printed PLA colla-gen-minocycline- nanoHydroxyapatite scaffold with combined antimicrobial and osteogenic effects for bone regeneration,” Mater. Sci. Eng., C, vol. 101, no. 8, pp. 15–26, 2019. https://doi.org/10.1016/j.msec.2019.03.056.

4. I. Gendviliene, et al.., “Assessment of the morphology and dimensional accuracy of 3D printed PLA and PLA/HAp scaffolds journal of the mechanical behavior of biomedical,” Materials, vol. 104, no. 4, 2020, Art. no. 103616. https://doi.org/10.1016/j.jmbbm.2020.103616.

5. F. A. Santos, et al.., “Low velocity impact response of 3D printed structures formed by cellular metamaterials and stiffening plates: PLA vs. PETg,” Compos. Struct., vol. 256, no. 1, 2021, Art. no. 113128. https://doi.org/10.1016/j.compstruct.2020.113128.