Microstructure and corrosion properties of SiC/Al-Mg-Cu-Si-Sn composites-Reference-Cited by-同舟云学术

Microstructure and corrosion properties of SiC/Al-Mg-Cu-Si-Sn composites

Published:2017-09-26 Issue:5 Volume:24 Page:709-713
ISSN:2191-0359
Container-title:Science and Engineering of Composite Materials
language:
Short-container-title:

Author:

Shen Rujuan¹,Zhou Pengfei¹,Xiao Daihong²,Song Min¹

Affiliation:

1. State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China

2. State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China, Phone: +86-731-88877880, Fax: +86-731-88710855

Abstract

AbstractThe SiC/Al-Mg-Cu-Si-Sn composites with different quantities of SiC particles by volume were fabricated using hot-pressing sintering. The effects of SiC volume fraction on the microstructure, Vickers hardness, and corrosion behavior of the composites were studied using the optical microscope, scanning electron microscope, Vickers hardness test, and corrosion testing. The results show that adding SiC particles shortened the time required to reach the peak-aged state of the composites and increased the hardness. Corrosion potentials of the composites did not vary greatly or show any definite trends in relation to the amounts of the SiC contents.

Publisher

Walter de Gruyter GmbH

Subject

Materials Chemistry,Ceramics and Composites

Link

https://www.degruyter.com/document/doi/10.1515/secm-2015-0280/pdf

Reference48 articles.

1. Degradation processes in Al/SiCp/MgAl2O4 composites prepared from recycled aluminum with fly ash and rice hull ash

2. Effect of SiC volume fraction on the age-hardening behavior in SiC particulate-reinforced 6061 aluminum alloy composites

3. Fabrication of Al–7wt%Si–0.4wt%Mg/SiC nanocomposite powders and bulk nanocomposites by high energy ball milling and powder metallurgy

4. Corrosion inhibition of T-6 treated 6061 Al-SiC(p) composite in hydrochloric acid

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Optimization of erosion wears of Al–Mg–Si–Cu–SiC composite produced by the PM method;Corrosion Reviews;2020-12-24