Affiliation:
1. School of Metallurgical Engineering, Anhui University of Technology , Maanshan , Anhui, 243002 , P R China
2. Anhui International Joint Research Center for Metallurgical Process and System Science, Anhui University of Technology , Maanshan , Anhui, 243002 , P R China
Abstract
Abstract
The Ti-bearing oxides are introduced into HRB400 steel melt through external addition method (EAM, TiO2) and internal precipitation method (IPM, Ti alloy) using a vacuum induction furnace, respectively. For each experiment, the instantaneous evolution of oxide properties was investigated through the analysis of intermediate samples. For the EAM method, it was found that the titanium content gradually increased with increase in the treatment time. Similar increasing trend is also observed for Ti-bearing oxide properties, such as the number density and normalized titanium content. These phenomena are totally different from those in the IPM intermediate samples, in which both Ti content and Ti-bearing oxide features show rapid increase, reaching saturation at 1 min after the addition of Ti alloy, and remain relatively stable thereafter. This comparison hints that after TiO2 addition, they first dissolve in molten steel, then decompose, and finally again form Ti-bearing oxides. Furthermore, in the case of similar titanium content, EAM intermediate samples exhibit higher Ti-bearing oxide number density and higher normalized titanium content compared to IPM samples. After heat treatment, the intragranular ferrite nucleation was observed in cast sample of EAM, which was induced by the introduced Ti-bearing oxides.