Preparation of rigid polyurethane foams with powder filler

Abstract

Abstract The diversified properties of polyurethane (PUR) foam plastics result from differences in the receipts applied during their preparation. The preparation of rigid polyurethane-polyisocyanurate foams (PUR-PIR) with application of different amounts of polyvinyl chloride (PVC) s-70 as a filler is described in this study. It was found that application of PVC s-70 has an effect on the prolongation of processing parameters, i.e., start time and, to a greater extent, expansion and gelation times. Moreover, it was found that introduction of filler into the foam composition causes a reduction in the capacity of the foam to absorb water; however, a distinct change in the amount of closed cells in comparison with standard foam was not observed. A favorable effect of filler on brittleness and flammability of PUR-PIR foams (significant reduction) as well as on compressive strength and softening point (a significant increase in these values) was observed.