Identifying the Dimensional Characteristics of the Cone Surfaces for the Transmission Synchronization Members-Reference-Cited by-同舟云学术

Identifying the Dimensional Characteristics of the Cone Surfaces for the Transmission Synchronization Members

Published:2017-10-26 Issue:1 Volume:14 Page:24-26
ISSN:2451-3156
Container-title:Technological Engineering
language:en
Short-container-title:

Author:

Pobijak Jozef¹,Czan Andrej¹,Czánová Tatiana¹,Daniš Igor¹,Holubják Jozef¹,Martinček Juraj¹,Pustay Jozef¹

Affiliation:

1. Department of Machining and Manufacturing Engineering, Faculty of Mechanical Engineering, University of Žilina, Žilina , Slovakia

Abstract

Abstract The article is about auxiliary equipment into service, specifically, it is control device which is to be designed to check the components for synchronization speed between gears in cars. In the introduction of article is described substance and necessary these equipment into in enterprises, their technical and economic importance. The core of the article readers will know firstly with a component for which is a device design. The most important on a component will be a measured parameters. Next in the core of the article, is described and illustrated design of the device with a brief functional description and control procedure. Of course that in the article is drafted verification of device capability with using the statistical method, where is the functionality of the device is expressed using indexes Cgm a Cgmk . Benefits, asset and evaluation of work for the application area are listed at the end of this article.

Publisher

Walter de Gruyter GmbH

Reference9 articles.

1. [1] Drbul, M., Sajgalik, M., Semcer, J., Czanova, T., Petrkovska, L., Cepova, L.: Metrology and Quality of Surfaces Created by Machining Technologies, 1st ed. (in Slovak), Zilina, 2014. ISBN 978-80-89276- 45-5

2. [2] Cep R., Janasek A., Petru J., Sadilek M., Mohyla P., Valicek J., Harnicarova M., Czan A. Surface Roughness after Machining and Influence of Feed Rate on Process. Key Engineering Materials, Vol. 581, 2014, pp. 341-347.

3. [3] Mital D., Michalik P., Zivcak J., Czan A., Stancekova D., Radchenko S., Vybostek J. Study the Quality of Welded Joints of Steel S235. Applied Mechanics and Materials, Vol. 718, 2015, pp 88-92.

4. [4] Stancekova D., Sajgalik, M., Petru J., Naprstkova, J., Balaz, P.: Implementation of coating for failure elimination of dial gauges In Metal 2015 - 24th international Conference on Metallurgy and Materials, conference proceeding, pp. 1162-1169, ISBN 978-808729462-8

5. [5] http://feinmesssuhl.com/fileadmin/user_upload/pdf/FMS_Katalog_PMS.pdf [14.5.2014].