The Influence of Measurement Methodology on the Accuracy of Electrical Waveform Distortion Analysis-Reference-Cited by-同舟云学术

The Influence of Measurement Methodology on the Accuracy of Electrical Waveform Distortion Analysis

Published:2018-04-01 Issue:2 Volume:18 Page:72-78
ISSN:1335-8871
Container-title:Measurement Science Review
language:en
Short-container-title:

Author:

Bartman Jacek¹,Kwiatkowski Bogdan¹

Affiliation:

1. Department of Computer Engineering, Faculty of Mathematics and Natural Sciences , University of Rzeszow , 35-959 Rzeszow , Poland

Abstract

Abstract The present paper covers a review of documents that specify measurement methods of voltage waveform distortion. It also presents measurement stages of waveform components that are uncommon in the classic fundamentals of electrotechnics and signal theory, including the creation process of groups and subgroups of harmonics and interharmonics. Moreover, the paper discusses selected distortion factors of periodic waveforms and presents analyses that compare the values of these distortion indices. The measurements were carried out in the cycle per cycle mode and the measurement methodology that was used complies with the IEC 61000-4-7 norm. The studies showed significant discrepancies between the values of analyzed parameters.

Publisher

Walter de Gruyter GmbH

Subject

Instrumentation,Biomedical Engineering,Control and Systems Engineering

Reference26 articles.

1. [1] Shmilovitz, D. (2005). On the definition of total harmonic distortion and its effect on measurement interpretation. IEEE Transactions on Power Delivery, 20 (1), 526-528.

2. [2] Binkowski, T. (2016). Influence of current sampling frequency on voltage source inverter fuzzy correction. In 13th Selected Issues of Electrical Engineering and Electronics (WZEE). IEEE.

3. [3] Kamuda, K., Klepacki, D., Kuryło, K. Sabat, W. (2015). Statistical analysis of influence of the low-power nonlinear loads on deformation of supply voltage. Przegląd Elektrotechniczny, 91 (8), 19-22. (in Polish)

4. [4] Sobczynski, D. (2015). A concept of a power electronic converter for a BLDC motor drive system in aviation. Aviation, 19 (1), 36-39.

5. [5] Rezmer, J., Leonowicz, Z., Gono, R. (2011). Analysis of distorted waveform in power converter systems. Przegląd Elektrotechniczny, 87 (1), 254-257.

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Synchronized Approach Based on Empirical Fourier Decomposition for Accurate Assessment of Harmonics and Specific Supraharmonics;IEEE Transactions on Industrial Electronics;2024

2. The effect of friction and wear behavior on the signal transmission of brush-ring system during electrical contact sliding;2022-11-02

3. Analysis of the use of the Hanning Window for the measurement of interharmonic distortion caused by close tones in IEC standard framework.;Electric Power Systems Research;2022-05

4. Problem of Total Harmonic Distortion Measurement Performed by Smart Energy Meters;Measurement Science Review;2022-01-21

5. Identification of Electrical Appliances Using Their Virtual Description and Data Selection for Non-Intrusive Load Monitoring;IEEE Transactions on Consumer Electronics;2021-11