Antifouling improvement of a polyacrylonitrile membrane blended with an amphiphilic copolymer

Abstract

Abstract The amphiphilic copolymer polyacrylonitrile-co-poly(hydroxyethyl methacrylate) (PAN-co-PHEMA) was readily blended with polyacrylonitrile (PAN) to fabricate a flat-sheet blending membrane through non-solvent induced phase separation (NIPS). In the membrane-forming process, the hydrophilic PHEMA chains are uniformly distributed on the surface, as revealed by the energy-dispersive X-ray tests. The sponge-like sub-layer embedded with droplet-shaped structures is formed at the cross-sections of membranes, because of the high viscosity of the casting solution. With the increase of copolymer concentration, the mean pore size of the blending membranes increases from 26.9 to 99.8 nm, leading to the increase of membrane flux from 93.6 to 205.4 l/(m2h). The incorporation of PAN-co-PHEMA copolymer endows the blending membrane with a rough surface microstructure and enhanced hydrophilicity. The rejection ratio of membranes for emulsified pump oil reaches 99.9%, indicating a prominent separation performance. In the cycle permeation experiments, the flux recovery ratio of the blending membranes is as high as 99.6%, which is much higher than those of PAN membrane. The irreversible fouling of blending membranes induced by oil adsorption is alleviated, and converted into reversible fouling, owing to the reduction of the adhesion force between foulant and membrane surface. These results suggest that the anti-fouling property of PAN membranes has been dramatically strengthened via the addition of PAN-co-PHEMA copolymer.