Design of evaluation tool used to improve the production process-Reference-Cited by-同舟云学术

Design of evaluation tool used to improve the production process

Published:2019-12-24 Issue:1 Volume:9 Page:641-649
ISSN:2391-5439
Container-title:Open Engineering
language:
Short-container-title:

Author:

Martina Hlatká¹,Karel Korec¹,Rudolf Kampf¹

Affiliation:

1. University of Vysoká škola technická a ekonomická v Českých Budějovicích, Department of Transport and Logistics, Okružní 17, Českých BudějovicíchCzech Republic

Abstract

AbstractThis paper is devoted to the use of statistical methods to ensure the highest quality processes. Specifically, it deals with creating an application in MS Excel which evaluates standard statistical parameters and if the required process capability indices are complied with, then it is possible to proceed to SPC (statistical process control). The application was created in MS Excel using the Visual Basic for Application programming language. In addition to the required calculations, the application also generates forms with all important data. This application was designed to reduce reject rate and improve the production process in a contracting company.

Publisher

Walter de Gruyter GmbH

Subject

Electrical and Electronic Engineering,Mechanical Engineering,Aerospace Engineering,General Materials Science,Civil and Structural Engineering,Environmental Engineering

Link

https://www.degruyter.com/document/doi/10.1515/eng-2019-0074/pdf

Reference42 articles.

1. Informative value of measrements for quality management of auto parts;Lecture Notes in Mechanical Engineering,2019

2. Bayesian Estimation of Parameters of Reliability and Maintainability of a Component under Imperfect Repair and Maintenance;Arabian Journal of Science and Engineerng,2019

3. Metodology of determination of key casting process parameters on DISA MATCH automatic moulding line affecting the formation of alloy-mould contact defects;Lecture Notes in Mechanical Engineering,2019

4. Metodology of determination of key casting process parameters on DISA MATCH automatic moulding line affecting the formation of alloy-mould contact defects;Lecture Notes in Mechanical Engineering,2019