Thickness Influence on the Creep Response of DD6 Ni-Based Single-Crystal Superalloy

Abstract

AbstractThe effect of specimen thickness on the creep response of Ni-based single-crystal superalloy DD6 was investigated. With the thickness of 0.3 mm, 0.6 mm and 1.2 mm, a series of thin-wall specimens were tested in this paper respectively at 760℃, 980℃ and 1,100℃. Under the conditions of lower temperatures and higher stresses, the creep life of thin-wall specimens increases with the increase of δ, but it is almost equal under higher temperatures and lower stresses conditions. Compared with the standard specimens, an obvious reduction (about 60%) of creep life of the thin-wall specimens was found at 760℃, whereas it is almost the same at 980℃ and 1,100℃. Therefore, obvious thickness effect is prone to lower temperature and higher stress. The thickness effect is a comprehensive effect, which is caused by fracture mode, the degree of necking, the shape and quantity of creep cavities, oxide thickness, etc. Under each condition, an increased thickness resulted in increased creep strain to rupture.