On-line monitoring of steel ball stamping by mechatronics cold heading equipment based on PVDF polymer sensing material-Reference-Cited by-同舟云学术

On-line monitoring of steel ball stamping by mechatronics cold heading equipment based on PVDF polymer sensing material

Published:2022-01-01 Issue:1 Volume:11 Page:168-174
ISSN:2192-8029
Container-title:Nonlinear Engineering
language:en
Short-container-title:

Author:

Wang Xing¹²,Wu Mingming¹,Wang Jianglong³

Affiliation:

1. School of Mechanical Engineering, Anhui Sanlian University , Hefei , Anhui, 230601 , China

2. School of Engineering, University of San Carlos , Cebu 6000 , Philippines

3. School of Mechanical Engineering, Hefei University of Technology , Hefei , Anhui, 230009 , China

Abstract

Abstract In order to explore the influence of cold heading equipment based on polyvinylidene fluoride (PVDF) polymer sensing material on steel ball stamping, a new method was proposed to reflect the defects of cold heading forming of steel ball by load signal. PVDF piezoelectric film is used as the sensor design of force and support structure of steel ball cold heading electromechanical sensor model. PVDF piezoelectric thin film force sensor is used for the structural optimization and simulation. The structural parameters affecting the natural frequency are numerically analyzed by MATLAB software. The mapping relationship between the external load and the output load of the sensor is obtained by using ANSYS software, and the simulation curve of the natural frequency of the sensor is compared with the theoretical curve to verify the factors affecting the natural frequency. The results show that the nonlinear error of sensors refers to the measured curve and the maximum deviation between the fitting line and the percentage of full-scale output.

Publisher

Walter de Gruyter GmbH

Subject

Computer Networks and Communications,General Engineering,Modeling and Simulation,General Chemical Engineering

Link

https://www.degruyter.com/document/doi/10.1515/nleng-2022-0014/pdf

Reference12 articles.

1. Chaus AS, Sitkevich MV, Pokorn P, Sahul M, Babincová P. Wear resistance and cutting performance of high-speed steel ball nose end mills related to the initial state of tool surface. Wear. 2021;472–473:203711.

2. Sanchez LC, Beatrice C, Lotti C, Marini J, Costa LC. Rheological approach for an additive manufacturing printer based on material extrusion. Int J Adv Manuf Technol. 2019;105(5–6):1–12.

3. Dacol V, Caetano E, Correia JR. A combined exponential-power-law method for interconversion between viscoelastic functions of polymers and polymer-based materials. Polymers. 2020;12(12):3001.

4. Jing J, Liu Y, Cong L, Zhang B, Lu W, Zhang X, et al. High-performance PVDF-HFP based gel polymer electrolyte with a safe solvent in Li metal polymer battery. J Energy Chem. 2020;49(10):96–104.

5. Bystrov VS, Bdikin IK, Silibin MV, Meng XJ, Paramonova EV. Pyroelectric properties of ferroelectric composites based on polyvinylidene fluoride (PVDF) with graphene and graphene oxide. Ferroelectrics. 2019;541(1):17–24.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. A Review of Plasma-Synthesized and Plasma Surface-Modified Piezoelectric Polymer Films for Nanogenerators and Sensors;Polymers;2024-05-30