The research of anti corrosive properties of various compositions on samples of standard metals-Reference-Cited by-同舟云学术

The research of anti corrosive properties of various compositions on samples of standard metals

Published:2017-12-01 Issue:4 Volume:19 Page:80-86
ISSN:1899-4741
Container-title:Polish Journal of Chemical Technology
language:en
Short-container-title:

Author:

Aghazada Y.J.¹,Abbasov Vaqif M.¹,Abdullayev Sanan E.¹,Hasanov Elgun K.¹,Suleymanova Sevinc S.¹

Affiliation:

1. Azerbaijan National Academy of Sciences , Institute of Petrochemical Processes Named After Acad , Yu.G. Mamedaliyev, AZ1025 , Azerbaijan , Baku , Khojali ave. 30

Abstract

Abstract In this proceeding. the compositions of the T-30 turbine oil with liquid rubber. Co. Ni. Zn. Mg and Ba salts of the natural petroleum acids (NPA) boiling in the range 220–340°C and nitro compounds which are produced on the basis of C14H28 α-olefins have been investigated in different ratio and contents as metalworking fluids (MWF). The physical and chemical properties of the produced compositions have been studied. and the morphology of inhibited carbon steel surface was analyzed and characterized by using Fourier transform infrared (FTIR) and scanning electron microscopy (SEM) techniques. The effect of the temperature on the inhibition efficiency and thermodynamic parameters have also been reported. The thermal analyzer was used for the thermogravimetric analysis (TG/DTA) of the prepared MWF. The experiments have been operated with different concentrations of the inhibitor on the steel plates in condensation and environment phases in the experiment chamber.

Publisher

Walter de Gruyter GmbH

Subject

General Chemical Engineering,General Chemistry,Biotechnology

Reference27 articles.

1. 1. Rozenfeld, I.L. 1981. Corrosion Inhibitors; McGraw-Hill. New York. p. 182.

2. 2. Roberge, P.R. 2008. Corrosion Engineering Principle and Practice. McGraw-Hill. New York. 730 p.

3. 3. McCoy, J.S. (2006). Introduction: Tracing the Historical Development of Metalworking Fluids, in Metalworking Fluids; Byers. J.P. Ed.; 2nd edition. Taylor & Francis. New York. pp. 1–18.

4. 4. Brinksmeier, E., Meyer, D., Huesmann-Cordes, A.G. & Herrmann, C. (2015). Metalwor-king fluids-Mechanisms and performance. CIRP Ann. Manufact. Technol. 64, 605–628 (http://creativecommons.org/licenses/by-nc-nd/4.0/).

5. 5. Hugh Spikes (2008). Low- and zero-sulphated ash. phosphorus and Sulphur anti-wear additives for engine oils. Lubrication Sci. 20, 103–136 DOI: 10.1002/ls.57.10.1002/ls.57

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Investigation of the inhibitory-bactericidal effect of amidoamine-based inorganic complexes against microbiological and atmospheric corrosion;Polish Journal of Chemical Technology;2020-09-01