Experience with application of reagent to heat transfer surfaces of combustion device-Reference-Cited by-同舟云学术

Experience with application of reagent to heat transfer surfaces of combustion device

Published:2017-06-01 Issue:2 Volume:19 Page:1-5
ISSN:1899-4741
Container-title:Polish Journal of Chemical Technology
language:en
Short-container-title:

Author:

Blahůšková Veronika¹,Vlček Jozef¹,Grycová Barbora¹,Jančar Dalibor¹,Velička Marek¹

Affiliation:

1. VSB – Technical University of Ostrava , Institute of Environmental Technology , 17. listopadu 15/2172, Ostrava -Poruba 708 33 , Czech Republic

Abstract

Abstract The formation of deposits on heat exchange surfaces of combustion equipment causes a decrease in heat exchange, a decrease in power, and consequently deterioration in the economic balance of combustion equipment. The technology of French company A. I. T. DRIVEX has been developing and being applied in practice for many decades. Preventive technology is used as a mean reagent periodically injected during operation into the combustion chamber. Part of the application is always pre-prepared project resolving the location of the injection nozzles into the combustion chamber on the flue gas path. The article describes the experimental usage of reagent GEPERSUITE 2200 at the Sermaize refinery in France. The aim of the test is to evaluate the benefits and advantages of applied technology in the boiler refinery in full operation. The results clearly demonstrate that using the reagent GEPERSUITE 2200 is advantageous in terms of economic and technical properties.

Publisher

Walter de Gruyter GmbH

Subject

General Chemical Engineering,General Chemistry,Biotechnology

Reference21 articles.

1. 1. Jiang, D., Xu, H., Khan, H.I., Deng, B. & Zhang, N. (2017). Transport of corrosion products in the steam-water cycle of supercritical power plant. Therm. Engineer. 113, 1164–1169. DOI: 10.1016/j.applthermaleng.2016.11.119.

2. 2. Bilitewski, B., Härdtle, G. & Marek, K. (1994). Waste Management. Berlin Heidelberg, Germany: Springer-Verlag. ISBN: 3-540-59210-5.

3. 3. Obroučka, K. (2003). Thermal waste treatment and energy recovery. 1st edition. Ostrava: VSB-Technical University of Ostrava. ISBN 80-248-0009-8.

4. 4. Leskens, M., van Kessel, L.B.M. & Bosgra, O.H. (2005). Model predictive control as a tool for improving the process operation of MSW combustion plants. Waste Managem. 25, 8, 788–798. DOI: 10.1016/j.wasman.2005.03.005.

5. 5. Kuriger, R., Young, D., Mackenzie, M., Sarv, H. & Trembly, J. (2017). Phase analysis of scale deposition in boiler tubes utilizing steam-assisted gravity drainage produced water. J. Therm. Sci. Engineer. Appl. 9 (1), 011009. DOI: 10.1115/1.4034598.