TIG-weldability of AISI 430 and DUROSTAT 500 grade-Reference-Cited by-同舟云学术

TIG-weldability of AISI 430 and DUROSTAT 500 grade

Published:2023-05-08 Issue:6 Volume:65 Page:952-960
ISSN:0025-5300
Container-title:Materials Testing
language:en
Short-container-title:

Author:

Aydin Sinan¹^ORCID

Affiliation:

1. Department of Mechatronics Engineering , Faculty of Technology, Sivas Cumhuriyet University , Sivas , 58140 , Türkiye

Abstract

Abstract In this study, 10 mm thick DUROSTAT 500 and AISI 430 grades were joined by double sided keyhole tungsten inert gas (K-TIG) welding method without using filler material. The characterization of the microstructure of the weld zone was investigated by optical analysis methods and the mechanical properties of the welded parts were examined by mechanical tests. The fracture surface structure of the parts that were broken as a result of the tests were examined. No deterioration was observed in the welded samples. It was determined that the weld penetration increased as a result of the increase in the amount of heat entering the weld zone with the increasing welding current.

Publisher

Walter de Gruyter GmbH

Subject

Mechanical Engineering,Mechanics of Materials,General Materials Science

Link

https://www.degruyter.com/document/doi/10.1515/mt-2022-0378/pdf

Reference17 articles.

1. K. Kumar, C. S. Kumar, M. Masanta, and S. Pradhan, “A review on TIG welding technology variants and its effect on weld geometry,” Mater. Today: Proc., vol. 50, pp. 999–1004, 2022, https://doi.org/10.1016/j.matpr.2021.07.308.

2. X. Chunyang, P. Zengxi, F. Zhenyu, Z. Shiyu, and L. Huijun, “Vision based defects detection for Keyhole TIG welding using deep learning with visual explanation,” J. Manuf. Process., vol. 56, pp. 845–855, 2020, https://doi.org/10.1016/j.jmapro.2020.05.033.

3. L. Z. Ming, F. Y. Xiao, C. S. Lin, et al.., “Stable keyhole welding process with K-TIG,” J. Mater. Process. Technol., vol. 238, pp. 65–72, 2016, https://doi.org/10.1016/j.jmatprotec.2016.07.005.

4. C. Shuwan, S. Yonghua, Z. Tao, and L. Weicong, “Microstructure, texture, and mechanical properties of Ti-6Al-4V joints by KTIG welding,” J. Manuf. Process., vol. 37, pp. 418–424, 2019, https://doi.org/10.1016/j.jmapro.2018.12.022.

5. F. Zhenyu, P. Zengxi, C. Dominic, et al.., “Investigation into the viability of K-TIG for joining armour grade quenched and tempered steel,” J. Manuf. Process., vol. 32, pp. 482–493, 2018, https://doi.org/10.1016/j.jmapro.2018.03.014.