Abstract
Stream flow rates and their several compositions are measured in a typical cement raw mill separator. In order to simultaneously reconcile flow and composition measurements in this circuit, the component mass balances was included as constraints which contain the products of flow rate and composition variables in the data reconciliation problem. In this paper, the effectiveness of simultaneous procedures for bilinear data reconciliation is established, the numerical problem constraints were coded in MATLAB and a mass balance model is built. Moreover, based on the difference between the measured and reconciled data it was found that it performs optimally.
Publisher
Engineering, Technology & Applied Science Research
Reference16 articles.
1. A. Spindler, “Structural redundancy of data from wastewater treatment systems. Determination of individual balance equations”, Water Res., Vol. 57, pp. 193–201, 2014
2. C. Karlsson, Tools for reconciliation of measurement data for processes at steady-state, Mälardalen University, 2004
3. H. Davidson, D. R. Kuehn, “Computer control II: mathematics of control”, Chem. Eng. Prog., Vol. 57, No. 6, pp. 1653-1672, 1961
4. V. Václavek, Studies on System Engineering. III: Optimal Choice of the Balance Measurements in Complicated Chemical Systems, Chemical Engineering Science, Vol. 24, No. 6, pp. 947-955, 1969
5. R. S. H. Mah, Chemical process structures and information flows, Elsevier, 1990
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献