Comparison between production controls in multi-stage multi-product manufacturing environments: two case studies-Reference-Cited by-同舟云学术

Comparison between production controls in multi-stage multi-product manufacturing environments: two case studies

Published:2014-01 Issue:1 Volume:2 Page:477-500
ISSN:2169-3277
Container-title:Production & Manufacturing Research
language:en
Short-container-title:Production & Manufacturing Research

Author:

Prakash J.¹,Chin J.F.²

Affiliation:

1. Faculty of Engineering and Green Technology, Universiti Tunku Abdul Rahman (UTAR), Jalan Universiti, Bandar Barat, 31900 Kampar, Perak, Malaysia

2. School of Mechanical Engineering, Universiti Sains Malaysia (USM), Engineering Campus, 14300 Nibong Tebal, Penang, Malaysia

Publisher

Informa UK Limited

Subject

Industrial and Manufacturing Engineering

Link

https://www.tandfonline.com/doi/pdf/10.1080/21693277.2014.925412

Reference76 articles.

1. Effect of dynamic and static dispatching strategies on dynamically planned and unplanned FMS

2. Policy Research Working Papers

3. Mass customisation — an automotive perspective

4. Araya, J. M. (2012). Value stream mapping adapted to high-mix, low-volume manufacturing environments (PhD thesis). KTH Industrial Engineering and Management.

5. A simulation study of new multi-objective composite dispatching rules, CONWIP, and push lot release in semiconductor fabrication

Cited by 5 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Application of vendor rationalization strategy for manufacturing cycle time reduction in engineer to order (ETO) environment;Journal of Manufacturing Technology Management;2019-01-21

2. Configuration of management accounting information system for multi-stage manufacturing;Journal of Physics: Conference Series;2018-05

3. Supply chain planning: a quantitative comparison between Lean and Info-Sharing models;Production & Manufacturing Research;2018-01

4. Application of value stream mapping (VSM) for lean and cycle time reduction in complex production environments: a case study;Production Planning & Control;2017-03-21

5. Evaluation of multi-product lean manufacturing systems with setup and erratic demand;Computers & Industrial Engineering;2015-09