Simulations of dust dynamics around a cone hood in updraft conditions-Reference-Cited by-同舟云学术

Simulations of dust dynamics around a cone hood in updraft conditions

Published:2018-10-03 Issue:10 Volume:15 Page:715-731
ISSN:1545-9624
Container-title:Journal of Occupational and Environmental Hygiene
language:en
Short-container-title:Journal of Occupational and Environmental Hygiene

Author:

Logachev K.I.¹^ORCID,Ziganshin A.M.²^ORCID,Averkova O.A.¹^ORCID

Affiliation:

1. Department of Heat and Gas Supply and Ventilation, Belgorod State Technological University named after V.G. Shoukhov, Belgorod, Russia;

2. Department of Thermal Power Engineering, Gas Supply and Ventilation Department, Kazan State University of Architecture and Engineering, Kazan, Tatarstan, Russia

Funder

Grants Council of the President of the Russian Federation

Publisher

Informa UK Limited

Subject

Public Health, Environmental and Occupational Health

Link

https://www.tandfonline.com/doi/pdf/10.1080/15459624.2018.1492137

Reference33 articles.

1. Reduced-scale experimental investigation on ventilation performance of a local exhaust hood in an industrial plant

2. Performance of constant exhaust ventilation for removal of transient high-temperature contaminated airflows and ventilation-performance comparison between two local exhaust hoods

3. A Study on the Improvement of Ventilation Rate Using Air-flow Inducing Local Exhaust Ventilation System

4. Local Exhaust Ventilation for the Control of Welding Fumes in the Construction Industry—A Literature Review

5. Influence of exhaust hood geometry on the capture efficiency of lateral exhaust and push-pull ventilation systems in surface treatment tanks

Cited by 23 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. A comprehensive study combing experiment and CFD simulation on the fume hood performance for nanoparticles and isopropanol control;Process Safety and Environmental Protection;2024-06

2. Determination of the Influence of the Oncoming Flow on the Vortex Zones at the Inlet to the Suction Sockets. Part 1. Flat Problem;Refractories and Industrial Ceramics;2023-07

3. Determination of the influence of the incoming flow on the vortex zones at the entrance to the suction sockets. Part 1. The flat problem;NOVYE OGNEUPORY (NEW REFRACTORIES);2023-05-31

4. Vortex zones in an exhaust hood in front of an impermeable plane;MAG CIV ENG;2023

5. Thermodynamic characteristics of an autonomous heat recuperator of flue gases of periodic action;AIP Conference Proceedings;2023