Affiliation:
1. Department of Earth Sciences, Memorial University of Newfoundland, Alexander Murray Building, 9 Arctic Ave, St. John’s, Newfoundland Canada A1B 3X5
2. Department of Earth Sciences, 240 Wallace Building, 125 Dysart Road, University of Manitoba, Winnipeg, Manitoba R3T 2N2, Canada
Abstract
Abstract
The ABM deposit is a bimodal-felsic, replacement-style volcanogenic massive sulfide deposit located in the Finlayson Lake district, Yukon, Canada, that is hosted by back-arc-affinity felsic volcanic rocks of the Yukon-Tanana terrane. Massive sulfide mineralization occurs as a series of stacked and stratabound lenses subparallel to the volcanic stratigraphy, surrounded by an envelope of pervasive white mica and chlorite alteration. Three major mineral assemblages occur: (1) a pyrite-sphalerite assemblage enriched in Zn-Pb-As-Sb-Ag-Au that formed at temperatures ∼200–270 °C, (2) a pyrite-chalcopyrite-magnetite-pyrrhotite assemblage enriched in Cu-Bi-Se-Co that formed at temperatures ∼300–350 °C, and (3) a chalcopyrite-pyrrhotite-pyrite stringer assemblage formed at temperatures >300 °C. In situ analysis of the sulfur isotopic ratios (δ34S) using secondary ion mass spectrometry has been performed on sulfides (pyrite, pyrrhotite, chalcopyrite, galena, and arsenopyrite) from samples representative of the major mineral assemblages. The δ34S results range between +4.0 and +12.5‰. The pyrite-sphalerite assemblage has an average δ34S value of +6.6 ± 1.8‰ (n = 31), whereas the higher temperature assemblages have an average δ34S value of +9.9 ± 1.4‰ (n = 59). Examination of the δ34S values of adjacent mineral pairs shows that the sulfides were formed under disequilibrium conditions and were not significantly altered or re-equilibrated by greenschist facies metamorphism that affected the ABM deposit post-volcanogenic massive sulfide formation. The observed range of δ34S values suggests that H2S derived from thermochemical sulfate reduction of seawater sulfate and/or an igneous sulfur source as the likeliest sources of S for the sulfides in the ABM deposit. Modeling of thermochemical sulfate reduction of contemporaneous Late Devonian seawater sulfate (δ34S ∼ +25‰) at temperatures estimated for the fluids forming the ABM deposit mineral assemblages (200–350 °C) shows that the reduction of 5–30% of the seawater sulfate would result in isotopic signatures similar to those observed at the ABM deposit. This model also explains the distribution of δ34S values across the mineral assemblages, as thermochemical sulfate reduction at higher temperatures (350 °C) results in more isotopically positive δ34S values. Modeling of mixing lines between thermochemical sulfate reduction at different temperatures and an igneous sulfur source suggests that leaching of magmatic/volcanic rocks also acted as a source of sulfur and was a likely a major contributor (70–95%) to the hydrothermal fluid system at the ABM deposit.
Publisher
Mineralogical Association of Canada
Reference80 articles.
1. Sulfur isotopic composition of ophiolitic cupriferous iron sulfide deposits, Notre Dame Bay, Newfoundland;Bachinski,;Economic Geology,(1977)
2. Geology, mineralogy, and sulfur isotope geochemistry of the Sargaz Cu-Zn volcanogenic massive sulfide deposit, Sanandaj–Sirjan Zone, Iran;Badrzadeh,;Mineralium Deposita,(2011)
3. Genesis of the Wolverine volcanic sediment-hosted massive sulfide deposit, Finlayson Lake district, Yukon, Canada: Mineralogical, mineral chemical, fluid inclusion, and sulfur isotope evidence;Bradshaw,;Economic Geology,(2008)
4. Variations of sulphur isotope signatures in sulphides from the metamorphosed Ming Cu(-Au) volcanogenic massive sulphide deposit, Newfoundland Appalachians, Canada;Brueckner,;Mineralium Deposita,(2015)