Synthesis of a nanocomposite with holocellulose extracted from barley straw and montmorillonite, and optimization of the removal of methylene blue dye using the synthesized adsorbent

Abstract

AbstractIn this study, holocellulose was extracted from milled barley straw with different mesh sizes using Laccase enzyme. After extraction, a dual composite was made using montmorillonite clay to remove methylene blue dye from synthetic effluent. Results of different analysis methods including scanning electron microscope, Fourier transform infrared spectroscopy, and BET revealed that prepared nanocomposite presented desired specifications, and for smaller mesh sizes, derived holocellulose had higher quality due to high specific surface area. Response surface methodology was employed to reduce the number of experiments for methylene blue adsorption experiments and to achieve an empirical model for prediction of adsorption efficiency at different operating conditions. The effect of different factors including solution temperature, pH, initial dye concentration, and mesh size of milled barley straw on dye adsorption performance by prepared composite was examined. Maximum removal efficiency was obtained about 95% at temperature of 32 °C, pH of 8, initial dye concentration of 4 mg L−1, and mesh size of 70. Also, isotherm studies were performed on experimental data using Langmuir, Freundlich, Temkin, and Dubinin–Radushkevich isotherm models and results revealed that the adsorption process follows Langmuir model with maximum predicted adsorption capacity of 159 mg g−1, which implies monolayer adsorption. Moreover, thermodynamic study revealed that adsorption of methylene blue is endothermic and spontaneous while enthalpy and Gibbs free energy of adsorption are positive and negative, respectively. Finally, adsorption kinetic study determined that the pseudo-second-order kinetics model with correlation coefficient of about 1 best fitted the experimental results which is the characteristic of chemisorption process.