Influence of Polymer Surface Roughness on the Fractions of Transmitted, Reflected and Absorbed Energy in Operation of Laser Transmission Welding

Abstract

AbstractThe study of energy fractions plays a fundamental role in laser joining operations: from their knowledge, it is possible to calculate the amount of laser beam energy that is effectively available during the formation of chemical and physical bonds, and how much energy is dissipated. This study examines semi-crystalline polymers of polyamide 6.6 (PA), polyethylene terephthalate (PET), polytetrafluoroethylene (PTFE), and polypropylene (PP), semitransparent to light radiation, with the aim of studying the influence of surface roughness on the distribution of energy fractions, and in particular on the reflection portion. For this purpose, polymeric samples with different surface finishing were prepared and characterized by profilometric analysis. Subsequently, an experimental setup was implemented to directly measure the transmitted ratio, obtaining the reflected energy fraction from the Beer-Lambert law, and the absorbed ratio by energy balance. The results showed a decrease in the power transmitted by polymers subjected to surface treatment, due to an increase in the reflection fraction, a phenomenon particularly evident for PET, for which the reflection share increased from ~ 0.5% to ~ 15.3%, following P240 treatment. A lower influence was verified for PA and especially PTFE, due to a lower influence of the treatment on surface morphology. On the basis of the experimental results, it is hypothesised that roughening the lower section of the irradiated polymer could allow an increase in the total internal reflection fraction, favouring the joint at the interface point. Graphical Abstract