An effect of mold surface temperature on final product properties in the injection molding of high-density polyethylene materials-Reference-Cited by-同舟云学术

An effect of mold surface temperature on final product properties in the injection molding of high-density polyethylene materials

Published:2020-05-20 Issue:5 Volume:78 Page:2627-2644
ISSN:0170-0839
Container-title:Polymer Bulletin
language:en
Short-container-title:Polym. Bull.

Author:

Karagöz İdris^ORCID

Publisher

Springer Science and Business Media LLC

Subject

Materials Chemistry,Polymers and Plastics,Condensed Matter Physics,General Chemistry

Link

https://link.springer.com/content/pdf/10.1007/s00289-020-03231-2.pdf

Reference37 articles.

1. Chen SC, Li HM, Huang ST, Wang YC (2010) Effect of decoration film on mold surface temperature during in-mold decoration injection molding process. Int Commun Heat Mass Transf 37:501–505. https://doi.org/10.1016/j.icheatmasstransfer.2010.01.005

2. Kyas K, Cerny J, Stanek M, Manas M, Manas D, Senkerik V, Skrobak A (2012) Measuring of temperature and pressure in injection mold. Int J Math Comput Simul 6(6):600–607

3. Lucchetta G, Fiorotto M (2013) Influence of rapid mould temperature variation on the appearance of injection-moulded parts. J Mech Eng 59:683–688. https://doi.org/10.5545/sv-jme.2013.1001

4. Zhou X, Zhang Y, Mao T, Zhou H (2017) Monitoring and dynamic control of quality stability for injection molding process. J Mater Process Technol 249:358–366. https://doi.org/10.1016/j.jmatprotec.2017.05.038

5. Kurt M, Kaynak Y, Kamber ÖS, Mutlu B, Bakır B, Koklu U (2010) Influence of molding conditions on the shrinkage and roundness of injection molded parts. Int J Adv Manuf Technol 46:571–578. https://doi.org/10.1007/s00170-009-2149-x

Cited by 17 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Multi-Objective Optimization of Injection Molding Parameters for Manufacturing Thin-Walled Composite Connector Terminals;Materials;2024-08-08

2. Crystallinity and mechanical properties of polypropylene products foamed by microcellular injection molding process;Journal of Applied Polymer Science;2024-03-16

3. High-Efficiency Polishing of Polymer Surface Using Catalyst-Referred Etching;International Journal of Automation Technology;2024-03-05

4. Effect of mold temperature on properties of hybrid biocomposites from semicrystalline polymers and agro-industrial by-products;Journal of Reinforced Plastics and Composites;2023-11-10

5. Cellular distribution and warpage deformation in double-sided in-mold decoration combined with microcellular injection molding process;Journal of Materials Processing Technology;2023-08