Author:
Metzmacher Andreas,Burgmann Sebastian,Janoske Uwe
Abstract
AbstractThin-film flows are frequently used in process engineering and are therefore of great interest in research. In most cases, waves occur which have a positive effect on the material and heat transport and significantly influence the dynamics of the film flow. A combination of µ-particle image velocimetry and confocal chromatic distance measurement is used to measure phase-averaged flow velocities in naturally developed film waves. A trigger signal is sent to the PIV system and a recording starts when a wave reaches the wave crest threshold. This makes it possible to trigger the µPIV system depending on the film thickness. The focus of this work is on the triggering of the wave crest. The functionality and quality of the measurements depend on the correct positioning of the confocal chromatic sensor, with the light spot at the level of the camera section. Simultaneously, the minimum, average, and maximum film thickness, as well as the wave amplitude and wave frequency, are recorded. Film flow is investigated on a glass plate at various angles (5°, 10°, 15°) of inclination, Reynolds numbers (30-200), and measurement positions. The results are compared with the theoretical solutions according to Nusselt. In addition, the influence of the tilt angle and the measuring position is explained. The measuring position, in particular, has a non-negligible influence since the characteristics of the film flow are largely dependent on the streamwise measuring position. Compared to the theoretical solutions according to Nusselt, the velocities and film thicknesses are significantly greater due to the presence of the waves. With increasing inclination angle and streamwise measuring position, the measured mean and maximum velocities of the film flow increase. They almost double when the inclination angle increases from 5° to 15°. When comparing the velocities depending on the measuring position (300–500 mm), it is noticeable that the velocities increase between 5 and 15%, depending on the angle, due to wave development and gravity.
Funder
Bergische Universität Wuppertal
Publisher
Springer Science and Business Media LLC
Subject
Fluid Flow and Transfer Processes,General Physics and Astronomy,Mechanics of Materials,Computational Mechanics
Reference22 articles.
1. Adomeit P, Renz U (2000) Hydrodynamics of three-dimensional waves in laminar falling films. Int J Multiph Flow 26(7):1183–1208
2. Alekseenko SV, Nakoryakov VY, Pokusaev BG (1985) Wave formation on a vertical falling liquid film. AIChE J 31(9):1446–1460
3. Al-Sibai F (2004) Experimentelle Untersuchung der Strömungscharakteristik und des Wärmeübergangs bei welligen Rieselfilmen. PhD thesis, Rheinisch-Westfälische Technische Hochschule Aachen, Aachen
4. Ausner I (2006) Experimentelle Untersuchungen mehrphasiger Filmströmungen. PhD thesis, Technische Universität Berlin, Berlin
5. Bilsing C, Radner H, Burgmann S, Czarske J, Büttner L (2022) 3D imaging with double-helix point spread function and dynamic aberration correction using a deformable mirror. Opt Lasers Eng 154:107044