Author:
Dudziak T.,Chandran P.,Nowak B.,Verma B.,Roth J.-P.,Rząd E.,Chat-Wilk K.,Polkowska A.,Samy V. Narayana,Reich S.,Jahns K.,Krupp U.
Abstract
AbstractVDM alloy (AM) 699 XA (AM-XA) produced by laser powder bed fusion (LPBF) was subjected to steam oxidation at different high temperatures. Initial studies on mass gain of AM-XA at 650 °C after 500 hours revealed insignificant changes. Typical to high temperatures, a wide range of oxides were obtained at 750 and 950 °C associated with mass gain. To fully understand AM-XA material behavior at high temperatures, hot-rolled 699 XA (HR-XA) was also fabricated and tested under similar conditions. At 750 °C, HR-XA showed a higher mass gain in comparison with AM-XA, whereas at 950 °C mass gain of AM-XA overtook HR-XA. This anomalous behavior was related mostly to carbide formation. In-depth anomalous behavior of AM-XA is explained by investigating the microstructure and phase composition of the oxidation products formed.
Publisher
Springer Science and Business Media LLC
Reference48 articles.
1. J. Bhattacharjya, S. Tripathi, A. Taylor, M. Taylor, and D. Walters, Additive Manufacturing: Current Status and Future Prospects, Collaborative Systems for Smart Networked Environments. L.M. Camarinha-Matos, H. Afsarmanesh Ed., Springer, Berlin, 2014
2. S. Zhang, B. Lane, J. Whiting, and K. Chou, On Thermal Properties of Metallic Powder in Laser Powder Bed Fusion Additive Manufacturing, J. Manuf. Process., 2019, 47, p 382–392.
3. X. Jinghao, R. Paraskevas Kontis, L. Peng, and J. Moverare, Modelling of Additive Manufacturability of Nickel-based Superalloys for Laser Powder Bed Fusion, Acta Mater., 2022, 240, p 118307.
4. Qi. Chao, V. Cruz, S. Thomas, N. Birbilis, P. Collins, A. Taylor, P.D. Hodgson, and D. Fabijanic, On the Enhanced Corrosion Resistance of a Selective Laser Melted Austenitic Stainless Steel, Scr. Mater., 2017, 141, p 94–98.
5. V.B. Vukkum and R.K. Gupta, Review on Corrosion Performance of Laser Powder-Bed Fusion Printed 316L Stainless Steel: Effect of Processing Parameters, Manufacturing Defects, Post-processing, Feedstock, and Microstructure, Mater. Des., 2022, 221, 110874.