Manufacturer calibrations of GPS transmit antenna phase patterns: a critical review

Abstract

AbstractOver the past decade, the Global Positioning System has released pre-flight calibrations for the transmit antennas of the Block IIR/IIR-M, Block IIF, and GPS III satellites that make up the current GPS constellation. Frequency-specific phase variations (PHVs) provided as part of these data sets are of key interest for an accurate and consistent modeling of GNSS carrier phase observations in precise point positioning applications as well as orbit and clock offset determination of the GPS satellites themselves. For proper utilization of the manufacturer calibrations, complementary information on the phase center offset (PCO) from the spacecraft center-of-mass is required. We describe necessary processing steps for converting the raw phase calibrations of Lockheed Martin and Boeing into a representation compatible with antenna models of the International GNSS Service (IGS), and provide a detailed discussion of inherent assumptions for combining PHVs and PCOs from different sources. Comparison with estimated antenna data from globally distributed monitoring stations shows good consistency of PHVs and suggests the use of manufacturer-calibrated, azimuth-dependent patterns in future releases of the IGS antenna model. In terms of PCOs, the new Block IIF calibrations exhibit a systematic bias of about 12 cm from PCOs estimates based on the IGS20 reference frame. This value closely matches the bias observed for manufacturer calibrations of GPS III and Galileo satellites, and suggests a careful review of the contribution that GNSS can make to the scale definition of the International Terrestrial Reference Frame (ITRF).