Fracture of aircraft titanium alloys under high-frequency loading-Reference-Cited by-同舟云学术

Fracture of aircraft titanium alloys under high-frequency loading

Published:2023-02 Issue:2 Volume:5 Page:
ISSN:2523-3963
Container-title:SN Applied Sciences
language:en
Short-container-title:SN Appl. Sci.

Author:

Nikitin Alexander D.^ORCID,Shesterkin Pavel S.,Lopatin Sergey S.

Abstract

AbstractThe paper is devoted to the problem of fatigue failure of two-phase titanium alloy VT3-1 under the action of high-frequency cyclic loading. Samples for the tests were made from the compressor disk of aviation engine D30-Ku installed on Tupolev Tu-154 planes. Repeated alternating loading was carried out by displacements of small amplitude at 20 kHz, coinciding with the first harmonic of longitudinal elastic vibrations of the sample. Analysis of specimen fracture surfaces shows predominant subsurface fracture. Analysis of areas of fatigue nucleation allows identifying elements of microstructure associated with crack nucleation. The results of the study can be used in the interpretation of fracture scenarios of structural elements in operation. Increasing the resource of products under such loads is possible through the use of damping layers or tapes, where possible.

Funder

Ministry of Education and Science

Publisher

Springer Science and Business Media LLC

Subject

General Earth and Planetary Sciences,General Physics and Astronomy,General Engineering,General Environmental Science,General Materials Science,General Chemical Engineering

Link

https://link.springer.com/content/pdf/10.1007/s42452-022-05266-8.pdf

Reference48 articles.

1. Wanhill RJH, Oldersma A (1997) Fatigue and fracture in an aircraft engine pylon. National Aerospace Laboratory NLR, Amsterdam

2. Beynon JH, Brown MW, Lindley TC, Smith RA, Tomkins B (1999) In: Balkema AA (eds) Rotterdam engineering against fatigue. Springer London pp 1–10

3. Pronina PF, Sun Y, Tushavina OV (2020) Mathematical modelling of high-intensity heat flux on the elements of heat-shielding composite materials of a spacecraft. J of Appl Eng Sci 18(4):693–698. https://doi.org/10.5937/jaes0-28086

4. Babaytsev AV, Rabinskiy LN (2019) Design calculation technique for thick-walled composite constructions operating under high-speed loading. Per Tche Quim 16(33):480–489

5. Dobryanskiy VN, Rabinskiy LN, Tushavina OV (2019) Experimental finding of fracture toughness characteristics and theoretical modeling of crack propagation processes in carbon fiber samples under conditions of additive production. Per Tche Quim 16(33):325–336