Structure Modification upon Ultrasonic Processing of an AA4032 Piston Alloy: Comparison of Permanent Mold and Direct-Chill Casting

Abstract

AbstractPiston Al-Si alloys have very complex compositions and multi-phase heterogeneous structure, so it is necessary to control the formation of primary and eutectic compounds. In this study, the ultrasonic melt processing (USP) of a eutectic Al-Si piston alloy (AA4032-type) was performed in a permanent mold and during direct-chill (DC) casting to study its effects on the structure refinement and modification. The principal difference between these two ways of casting is that in the permanent mold the solidification front progressively moves towards the ultrasound source, while in the DC casting the position of the solidification front is fixed in space. The results showed that the USP can successfully refine primary Si, Fe-containing intermetallics and aluminum grains. Refinement of primary Si was accompanied by the increase in its amount, which was attributed to both enhanced heterogeneous nucleation and fragmentation. The refinement of Fe-containing intermetallics and Al grains resulted from the fragmentation mechanism and were more pronounced when USP was applied below the liquidus temperature in the permanent mold. However, the eutectic phases coarsened upon USP, and this effect was most pronounced when USP was applied to the semi-solid material. This was related to the strong attenuation of acoustic waves, which effectively heats the semi-solid material and induces corresponding coarsening of the phases. Acoustic streaming induced by an oscillating sonotrode affected the depth of the sump while simultaneously decreasing the macrosegregation, which reflects the dominant role of the melt flow directed against natural convection. The results demonstrated the importance of the solidification stage at which the USP was applied and the specifics of the USP mechanisms acting at the different stages of solidification.