Reformulating Ceramic Body Composition to Improve Energy Efficiency in Brick Manufacture

Abstract

AbstractThe influence of inorganic minerals (colemanite and nepheline syenite) as additives for sustainable clay brick manufacture has been examined. Each additive was added at 4 wt% to 96 wt% brick clay and samples were fired to 950 °C and 1040 °C and then compared with samples of 100% brick clay. Multiple analytical techniques (X-ray fluorescence, dilatometry, boiling water absorption, volumetric shrinkage, and mercury porosimetry) were used for analysis. Dilatometry shows that the additives influenced the temperature at which shrinkage began and the extent of that shrinkage. The use of colemanite reduced the temperature at which the shrinkage began by 120 °C and nepheline syenite reduced it by 20 °C. A linear shrinkage in dilatometry of 1% (from the maximum expanded length) was achieved at 1000 °C for 100% clay, 875 °C for colemanite additions and 970 °C for nepheline syenite additions. However, for samples fired at 1040 °C for 2 h colemanite containing samples had significantly lower volumetric shrinkage and higher water absorption than 100% clay and nepheline syenite samples, suggesting the presence of higher amounts of open porosity caused by the decomposition of the colemanite on heating. Samples containing nepheline syenite had a lower volumetric shrinkage but also a marginally lower water absorption than the 100% clay. The further optimisation of these or similar additives could potentially provide energy saving opportunities and reductions in CO2 emissions for brick manufacturers.