On the Nature of Critical Heat Flux in Microchannels
Author:
Bergles A. E.1, Kandlikar S. G.2
Affiliation:
1. Mechanical Engineering Department, Massachusetts Institute of Technology, Cambridge, MA 02139 2. Mechanical Engineering Department, Rochester Institute of Technology, Rochester, NY 14623
Abstract
The critical heat flux (CHF) limit is an important consideration in the design of most flow boiling systems. Before the use of microchannels under saturated flow boiling conditions becomes widely accepted in cooling of high-heat-flux devices, such as electronics and laser diodes, it is essential to have a clear understanding of the CHF mechanism. This must be coupled with an extensive database covering a wide range of fluids, channel configurations, and operating conditions. The experiments required to obtain this information pose unique challenges. Among other issues, flow distribution among parallel channels, conjugate effects, and instrumentation need to be considered. An examination of the limited CHF data indicates that CHF in parallel microchannels seems to be the result of either an upstream compressible volume instability or an excursive instability rather than the conventional dryout mechanism. It is expected that the CHF in parallel microchannels would be higher if the flow is stabilized by an orifice at the entrance of each channel. The nature of CHF in microchannels is thus different than anticipated, but recent advances in microelectronic fabrication may make it possible to realize the higher power levels.
Publisher
ASME International
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference33 articles.
1. Mehendale, S. S., Jacobi, A. M., and Shah, R. K., 2000, “Fluid Flow and Heat Transfer at Micro- and Meso-Scales with Application to Heat Exchanger Design,” Appl. Mech. Rev., 53(7), pp. 175–193. 2. Kandlikar, S. G., and Grande, W. J., 2003, “Evolution of Microchannel Flow Passages—Thermohydraulic Performance and Fabrication Technology,” Heat Transfer Eng., 24(1), pp. 3–17. 3. Cho, E. S., Koo, J.-M., Jiang, L., Prashar, R. S., Kim, M. S., Santiago, J. G., Kenny, T. W., and Goodson, K. E., 2003, “Experimental Study on Two-Phase Heat Transfer in Microchannel Heat Sinks with Hotspots,” Proceedings of 19th Semi-Therm Symposium, IEEE, Piscataway, NJ, pp. 242–246. 4. Tuckerman, D. B., and Pease, R. F. W., 1981, “High-Performance Heat Sinking for VLSI,” IEEE Electron Device Lett., EDL-2, pp. 126–129. 5. Hall, D. D., and Mudawar, I., 2000, “Critical Heat Flux (CHF) for Water in Tubes-II, Subcooled CHF Correlations,” Int. J. Heat Mass Transfer, 43, pp. 2605–2640.
Cited by
256 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
|
|