Affiliation:
1. School of Engineering, Cranfield University, Bedford MK43 0AL, UK
2. Manx Electricity Authority, Isle of Man, UK
Abstract
Accurate simulation and understanding of gas turbine performance is very useful for gas turbine users. Such a simulation and performance analysis must start from a design point. When some of the engine component parameters for an existing engine are not available, they must be estimated in order that the performance analysis can be carried out. However, the initially simulated design-point performance of the engine using estimated engine component parameters may give a result that is different from the actual measured performance. This difference may be reduced with better estimation of these unknown component parameters. However, this can become a difficult task for performance engineers, let alone those without enough engine performance knowledge and experience, when the number of design-point component parameters and the number of measurable/target performance parameters become large. In this paper, a gas turbine design-point performance adaptation approach has been developed to best estimate the unknown design-point component parameters and match the available design-point engine measurable/target performance. In the approach, the initially unknown component parameters may be compressor pressure ratios and efficiencies, turbine entry temperature, turbine efficiencies, air mass flow rate, cooling flows, bypass ratio, etc. The engine target (measurable) performance parameters may be thrust and specific fuel consumption for aero engines, shaft power and thermal efficiency for industrial engines, gas path pressures and temperatures, etc. To select, initially, the design point component parameters, a bar chart has been used to analyze the sensitivity of the engine target performance parameters to the design-point component parameters. The developed adaptation approach has been applied to a design-point performance matching problem of an industrial gas turbine engine GE LM2500+ operating in Manx Electricity Authority (MEA), UK. The application shows that the adaptation approach is very effective and fast to produce a set of design-point component parameters of a model engine that matches the actual engine performance very well. Theoretically, the developed techniques can be applied to other gas turbine engines.
Subject
Mechanical Engineering,Energy Engineering and Power Technology,Aerospace Engineering,Fuel Technology,Nuclear Energy and Engineering
Reference11 articles.
1. Adaptive Simulation of Gas Turbine Performance;Stamatis;ASME J. Eng. Gas Turbines Power
2. Lambiris, B., Mathioudakis, K., and Papailiou, K. D., 1991, “Adaptive Modeling of Jet Engine Performance With Application to Condition Monitoring,” ISABE Paper No. 91-7058.
3. Optimal Measurement and Health Index Selection for Gas Turbine Performance Status and Fault Diagnosis;Stamatis;ASME J. Eng. Gas Turbines Power
4. Kong, C., Ki, J., and Kang, M., 2002, “A New Scaling Method for Component Maps of Gas Turbine Using System Identification,” ASME Paper No. GT-2002-30150.
5. Kong, C., Kho, S., and Ki, J., 2004, “Component Map Generation for a Gas Turbine Using Genetic Algorithms,” ASME Turbo Expo 2004, June, ASME Paper No. GT2004-53736.
Cited by
43 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献