Film-Cooling Performance of a Turbine Vane Suction Side: The Showerhead Effect on Film-Cooling Hole Placement for Cylindrical and Fan-Shaped Holes

Abstract

In this paper, the transient IR-thermography method is used to investigate the effect of showerhead cooling on the film-cooling performance of the suction side of a turbine guide vane working under engine-representative conditions. The resulting adiabatic film effectiveness, heat transfer coefficient (HTC) augmentation, and net heat flux reduction (NHFR) due to insertion of rows of cooling holes at two different locations in the presence and absence of the showerhead cooling are presented. One row of cooling holes is located in the relatively high convex surface curvature region, while the other is situated closer to the maximum throat velocity. In the latter case, a double staggered row of fan-shaped cooling holes has been considered for cross-comparison with the single row at the same position. Both cylindrical and fan-shaped holes have been examined, where the characteristics of fan-shaped holes are based on design constraints for medium size gas turbines. The blowing rates tested are 0.6, 0.9, and 1.2 for single and double cooling rows, whereas the showerhead blowing is maintained at constant nominal blowing rate. The adiabatic film effectiveness results indicate that most noticable effects from the showerhead can be seen for the cooling row located on the higher convex surface curvature. This observation holds for both cylindrical and fan-shaped holes. These findings suggest that while the showerhead blowing does not have much impact on this cooling row from HTC enhancement perspective, it is influential in determination of the HTC augmentation for the cooling row close to the maximum throat velocity. The double-row fan-shaped cooling seems to be less affected by an upstream showerhead blowing when considering HTC enhancement, but it makes a major contribution in defining adiabatic film effectiveness. The NHFR results highlight the fact that cylindrical holes are not significantly affected by the showerhead cooling regardless of their position, but showerhead blowing can play an important role in determining the overall film-cooling performance of fan-shaped holes (for both the cooling row located on the higher convex surface curvature and the cooling row close to the maximum throat velocity), for both the single and the double row cases.