Effects of Orientation Angles on Film Cooling Over a Flat Plate: Boundary Layer Temperature Distributions and Adiabatic Film Cooling Effectiveness
Author:
Jung In Sung1, Lee Joon Sik1
Affiliation:
1. Turbo and Power Machinery Research Center, Department of Mechanical Engineering, Seoul National University, Seoul 151-742, Korea
Abstract
Presented are experimental results describing the effects of orientation angle of film cooling holes on boundary layer temperature distributions and film cooling effectiveness. Film flow data were obtained from a row of five film cooling holes on a flat test plate. The inclination angle of the hole was fixed at 35 deg and four orientation angles of 0, 30, 60, and 90 deg were investigated. The velocity ratios surveyed were 0.5, 1.0, and 2.0. The boundary layer temperature distributions were measured at three downstream locations using 1μm platinum wire. Detailed adiabatic film cooling effectiveness distributions were measured using thermochromic liquid crystal. Results show that the increased lateral momentum in the case of large orientation angle injection strongly affects boundary layer temperature distributions. Temperature distribution characteristics are, in general, explained in the context of the interactions between injectant and free-stream fluid and between injectants issuing from adjacent holes. The adiabatic film cooling effectiveness distributions are discussed in connection with the boundary layer temperature distributions. Spanwise-averaged effectiveness distributions and space-averaged effectiveness distributions are also presented with respect to the velocity ratios and the orientation angles. [S0889-504X(00)01701-3]
Publisher
ASME International
Subject
Mechanical Engineering
Reference11 articles.
1. Arts, T., and Bourguignon, A. E., 1990, “Behavior of a Coolant Film With Two Rows of Holes Along the Pressure Side of a High-Pressure Nozzle Guide Vane,” ASME J. Turbomach., 112, pp. 512–521. 2. Ligrani, P. M., Ciriello, S., and Bishop, D. T., 1992, “Heat Transfer, Adiabatic Effectiveness, and Injectant Distributions Downstream of a Single Row and Two Staggered Rows of Compound Angle Film Cooling Holes,” ASME J. Turbomach., 114, pp. 687–700. 3. Goldstein, R. J., Eckert, E. R. G., Eriksen, V. L., and Ramsey, J. W., 1970, “Film Cooling Following Injection Through Inclined Circular Tubes,” Isr. J. Technol., 8, No. 1–2, pp. 145–154. 4. Mehendale, A. B., and Han, J. C., 1992, “Influence of High Mainstream Turbulence on Leading Edge Film Cooling Heat Transfer,” ASME J. Turbomach., 114, pp. 707–715. 5. Honami, S., Shizawa, T., and Uchiyama, A., 1994, “Behavior of the Laterally Injected Jet in Film Cooling: Measurements of Surface Temperature and Velocity/Temperature Field Within the Jet,” ASME J. Turbomach., 116, pp. 106–112.
Cited by
70 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
|
|