Flow rate measurement in undamaged multicomponent geosynthetic clay liners

Abstract

ABSTRACT: The objective of the paper is the presentation of a test method to quantify advective flow rates through multicomponent geosynthetic clay liners (GCLs). A procedure was developed, combining measuring devices from EN 14150 for flow rate measurement through geomembranes and a rigid wall permeameter from NF P 84-705 aiming at measuring the flow rates through GCLs. Multicomponent GCLs by structure fall between geomembranes and GCLs. The resulting testing device allows measurement of very small variations of volume with time while applying constant hydraulic pressures. The pressure difference applied on both sides of the multicomponent GCL specimens varied between 25 kPa and 100 kPa, the latter value being equal to that applied across geomembranes in EN 14150, except in one case where the multicomponent liner had a light coating. In this case hydraulic heads of 0.3 and 0.6 m were applied. Four different multicomponent GCLs were tested, from three different manufacturers, in order to determine the ability of the testing equipment to quantify the flow rate through multicomponent GCLs. The flow rate measurement was performed after a hydration phase under a very low hydraulic head and a 10 kPa normal load on the specimens in accordance with NF P 84-705. Details are given of the experimental conditions that might lead to the development of a standard for the measurement of flow rates through multicomponent GCLs. Results obtained tend to show that flow rates are one order of magnitude larger than those usually measured for virgin geomembranes, that is 10–5 m3/(m2 d), except for one of the multicomponent GCLs for which the light coating resulted in larger flow rates, measured with hydraulic heads of 0.3 and 0.6 m. In this case values consistent with previous values from the literature in the range 1.4 × 10–11 m/s to 2.2 × 10–11 m/s were obtained.