Formation of the Surface Layer Properties in Edge Cutting Machining of Stainless and Heat-Resistant Steels-Reference-Cited by-同舟云学术

Formation of the Surface Layer Properties in Edge Cutting Machining of Stainless and Heat-Resistant Steels

Published:2019-11 Issue: Volume:973 Page:56-60
ISSN:1662-9752
Container-title:Materials Science Forum
language:
Short-container-title:MSF

Author:

Kraynev Dmitriy V.¹,Frolov Evgeniy M.¹,Norchenko Pavel A.¹

Affiliation:

1. Volgograde State Technical University

Abstract

The article considers features of a cutting process of stainless and heat-resistant steels and factors that determine difficulties in machining these materials. The mechanism of influence of advanced plastic deformation on the cutting process, wear of the cutting tool and formation of the quality parameters of the surface machined have been analyzed.

Publisher

Trans Tech Publications, Ltd.

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Link

https://www.scientific.net/MSF.973.56.pdf

Reference5 articles.

1. M.F. Poletika, On forces on the cutter back edge, Bulletin of Tomsk Polytechnic Institute (TPI). 188 (1974) 84-87.

2. A.A. Bondarev, D.V. Krainev, Yu.N. Polyanchikov, Increase in the efficiency of turning deformable steels and alloys with advanced plastic deformation: monograph, VSTU, Volgograd, (2015).

3. A. A. Bondarev, D. V. Kraynev, J. N. Otaniy, Yu. N. Polyanchikov, Reduction of temperature and force of tension of the cutting process when using the advanced plastic deformation, High technologies in mechanical engineering. 3 (2016) 40-44.

4. I.N. Kozachuhnenko, D.V. Kraynev, P.A. Norchenko, The problem of forecasting the facial layer quality while cutting steel with advance plastic deformation, in: A.A. Radionov (Eds.), Procedia Engineering, 2nd International Conference on Industrial Engineering (ICIE-2016), Elsevier publishing. 150 (2016) 821-826.

5. D.V. Krainev, M.Yu. Polyanchikova, A.A. Bondarev, Influence of the surface layer characteristics on the regularities of the cutting progress, MATEC Web of Conference. International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2017), 129: 01045 (2017).