Accuracy Analysis of the K&C Test-Rig Measuring System-Reference-Cited by-同舟云学术

Accuracy Analysis of the K&C Test-Rig Measuring System

Published:2013-07 Issue: Volume:333-335 Page:248-253
ISSN:1662-7482
Container-title:Applied Mechanics and Materials
language:
Short-container-title:AMM

Author:

Zhang Li Hao¹,Guo Kong Hui¹,Chen Shu Qi¹

Affiliation:

1. Jilin University

Abstract

Target parameters of the K&C test-rig is introduced in this paper. Establish McPherson independent suspension and K&C test-rig multi-body dynamics model .The measurement data of angle sensors is obtained in the wheel travel simulation. Accuracy analysis of target parameters when there are machining errors, installation errors and calibration errors in the measuring system. Accuracy analysis of target parameters when using the different measurement precision angle sensor. Comprehensively consideration of the measuring system all error factors, the accuracy is analyzed. The coordinate error of the installation point between measuring plate and the hub has greater effect on the toe and camber calculation.

Publisher

Trans Tech Publications, Ltd.

Link

https://www.scientific.net/AMM.333-335.248.pdf

Reference7 articles.

1. Resch, S., Lindner, F., and Gaffiné, R., Dynamic kinematics and compliance analysis for transient vehicle dynamic behaviour on intelligent test bench concept, , FISITA World Automotive Congress 2008, Congress Proceedings - Testing and Simulation 7(1): 185-189, (2008).

2. Holdmann, P. , Koehn, P., Moeller, B., and Willems, R., Suspension kinematics and compliance - measuring and simulation, , SAE Special Publications 1338(1): 91-96, Feb (1998).

3. Jing, L.X., and Guo, K.H., Kinematics and compliance characteristics of twist beam rear suspension, , Jilin Daxue Xuebao (Gongxueban)/Journal of Jilin University (Engineering and Technology Edition) 40(1): 1-5, Septeber (2010).

4. Wei, T.E. , Dorfi, H.R. , Vehicle suspension measurements: evaluation of the benefits of dynamic over quasistatic kinematics and compliance testing, , Tire Science and Technology 37( 1): 32-46, January/March (2009).

5. Guo, K.H., Li, N., Zhao, Y., Guo, C. et al., The development of a vehicle suspension Kinematics and Compliance facility, , 2011 International Conference on Electric Information and Control Engineering, ICEICE 2011 – Proceedings: 3691-3694, (2011).