Affiliation:
1. University of Blida 1
2. Université de Franche-Comté
3. Universiti Kebangsaan Malaysia (UKM)
Abstract
This paper identifies and investigates the influence of technological defects of manufacturing process on the dynamic behavior of thin chromium microbeam. The analytical models will be analyzed and corrected using finite element method (FEM) to determine their validity under influence of technological defects. A semi-analytical model will be proposed for the extraction of corrective factors from 3D FEM simulation of dynamic behavior of microbeam. Final results indicate that the correction of technological defects is very significant for Cr microbeam 80x2x0.95μm3. In other hand, the corrected value of Young’s modulus is very close to the experimental results and it is about 279.1GPa.
Publisher
Trans Tech Publications, Ltd.
Reference10 articles.
1. M.J. Madou, Fundamentals of Microfabrication: The Science of Miniaturization, second ed. CRC Press, Florida, (2002).
2. G. Piazza, P.J. Stephanou, A.P. Pisano, Single-chip multiple-frequency ALN MEMS filters based on contour-mode piezoelectric resonators. J. Microelectromech. Syst. 16(2) (2007) 319-328.
3. R Yahiaoui, Etude par microvibrométrie de films minces et de dispositifs micromécaniques, Ph.D. thesis, IEF, University of Paris XI, Paris, (2002).
4. R. Yahiaoui, A Bosseboeuf, Cantilever microbeams: modelling of the dynamical behavior and material characterization. Therm. Mech. Simulat. Exp. Microelectron. Microsyst. 2004. EuroSimE 2004. Proc. 5th Int. Conf. IEEE (2004) 377-384.
5. E.J. Boyd, V. Nock, X. Li, D. Uttamchandani, Density measurement of thin-films for micro-electromechanical systems using micro-cantilever structures, Thin Solid Films, 519 (2011) 7932-7935.
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献