Closest and long-term prospects of 3D-printing for obstetrics and gynecology-Reference-Cited by-同舟云学术

Closest and long-term prospects of 3D-printing for obstetrics and gynecology

Published:2021-07-12 Issue:1 Volume:20 Page:76-81
ISSN:2071-5943
Container-title:Ural Medical Journal
language:
Short-container-title:jour

Author:

Kudryavtseva E. V.¹^ORCID,Kovalev V. V.¹^ORCID,Zakurinova E. S.¹^ORCID,Muller-Kamskii G.²^ORCID,Popov V. V.²^ORCID

Affiliation:

1. Ural State Medical University

2. Israel Institute of metals, Technion’s R&D Foundation

Abstract

Introduction. Despite the notable and rapid progress in the development of medical 3D printing in recent years, not much is known about the use of this technology in obstetrics and gynecology.The purpose of our review of scientific literature was to determine the current level of 3D printing development, discuss the closest and long term prospects for using this technology in obstetrics and gynecology, and analyze its potential advantages and disadvantages.Materials and methods. We searched for scientific literature. 378 papers passed a three-step screening, as a result of which 42 sources were selected for the final scientific review.Results and discussion. The main areas in which dimensional printing can be used in this area of medicine is the creation of simulation models and training for students, the creation of anatomical models for preoperative preparation, the surgical instruments, the creation of new dosage drug forms (including transvaginal ones), and bioprinting of organs and tissues.Conclusion. The presented literary review allows us to conclude that 3D printing the obstetrics and gynecology is a current rapidly developing direction. The organization of 3D modeling and printing laboratories can significantly increase the efficiency of teaching students and residents. In addition, obstetricians-gynecologists and surgeons should be informed about the possibility of 3D printing surgical instruments according to an individual design. It can inspire them to implement their own ideas and develop domestic innovative developments. Three-dimensional printing of dosage forms and bioprostheses requires more complex technological solutions, and is not yet used in clinical practice. However, given the enormous prospects for these areas, various grants should be envisaged for their development in Russia

Publisher

Ural State Medical University

Reference42 articles.

1. Powder-bed additive manufacturing for aerospace application: Techniques, metallic and metal/ceramic composite aterials and trends / Katz-Demyanetz A., Popov V. V., Kovalevsky A. [et al.] // Manuf. Rev. – 2019. – Vol. 6. – Doi: 10.1051/mfreview/2019003.

2. Popov, V. V. Hybrid additive manufacturing of steels and alloys / V. V. Popov, A. Fleisher // Manuf. Rev. – 2020. – Vol. 7. – Doi: 10.1051/mfreview/2020005.

3. MakeShaper. Types of 3D Printing. – 2020. – Url: https://makeshaper.com/types-3d-printing/.

4. Selective laser sintering responses of keratin-based bio-polymer composites / S. Singamneni, R. Velu, M. P. Behera [et al.] // Mater. Des. – 2019. – Vol. 183. – Doi: 10.1016/j.matdes.2019.108087

5. Laser-based powder bed fusion of alumina toughened zirconia / F. Verga, M. Borlaf, L. Conti [et al.] // Addit. Manuf. – 2020. – Vol. 31. – Doi: 10.1016/j.addma.2019.100959.