Computational fluid dynamics investigation of bitumen residues in oil sands tailings transport in an industrial horizontal pipe

Abstract

Pipeline transport is commonly used in the oil sand industry to convey crushed oil sand ores and tailings. Bitumen residues in the oil sand tailings can be a threat to the environment that separating them from tailings before disposal is crucial. However, low bitumen concentration in the tailing slurry and the complex transport characteristics of the four-phase mixture make the process difficult. This study establishes an Eulerian–Eulerian (E–E) computational fluid dynamics model for an industrial-scale oil sand tailings pipeline. A comprehensive sensitivity analysis was conducted on the selection of carrier-solid and solid-bitumen drag models. The combination of small and large particle sizes (i.e., 75 and 700  μm) and bitumen droplet size (i.e., 400  μm) provided good agreement with field data in velocity profiles and pressure drop. The validated model was subsequently extended to investigate the influence of the secondary phase (i.e., bitumen droplets and bubbles) on flow characteristics in a tailing pipeline. The investigation covered a range of bitumen droplet size (100–400  μm), bitumen fraction (0.0025–0.1), bubble size (5–1000  μm), and bubble fraction (0.0025–0.3) and their influences on the velocity, solids, and bitumen distribution are revealed. For an optimum bubble size of 500  μm, a maximum recovery of 59% from the top 50% and 83% from the top 75% of the pipe cross section was obtained. The present study demonstrates the preferential distribution of bitumen and provides valuable insight into bitumen recovery from an industrial-scale tailing pipeline.