Investigation of novel passive methods of generation of swirl flow in supersonic separators by the computational fluid dynamics modeling

Abstract

AbstractIn this paper, three passive methods for the generation of swirl flow in the supersonic separator (3S) were investigated, and their structures were optimized by computational fluid dynamics (CFD) modeling. The influence of the structural and operational parameters on the dew point depression, phase envelope diagram, rate of natural gas liquid (NGL) recovery, and separation efficiency have also been evaluated. The collection efficiency was significantly improved for the nozzle equipped with the passive swirler compared with the simple nozzle. The selection of passive swirler type played a crucial role in the natural gas liquefaction and separation. The side injected swirler, and serpentine swirler showed the most significant improvement in separation efficiency than the U-turn swirler. For the side injected swirler at the optimum injection angle, the maximum collection efficiency was about 89% at the pressure loss ratio (PLR) of 0.2. Besides, the simulation results demonstrated that for the serpentine 3S, with the increase in serpentine twist number, the highest improvement on the collection efficiency of the investigated nozzle was obtained. In addition, it was observed that, when the convergent section profile was designed according to the Witoszynski line-type, a larger refrigeration zone was obtained than other considered profiles.