Optimization design of battery bracket for new energy vehicles based on 3D printing technology

Abstract

AbstractNowadays, what captures consumers' primary attention is how to purchase electric vehicles with long range and desirable price. Lightweight construction stands as one of the most effective approaches for prolonging range and lowering costs. As a consequence, it is particularly imperative to undertake lightweight design optimization for the battery bracket of new energy vehicles by applying 3D printing technology. To actualize this goal, Rhino software was initially employed for 3D modeling to design the battery bracket system for a pure electric vehicle in China. Subsequently, topology optimization design of the battery bracket was carried out by adopting Altair Inspire software. Last but not least, manufacturing and assembly inspection were completed using a 3D printer. The results show that the maximum displacement of the battery lower tray bracket after topology optimization is 3.20 mm, which is slightly higher than before, but still relatively small. The maximum Mises equivalent stress rose to 240.7 MPa post-optimization, but brought about a uniform stress distribution at the bottom of the bracket. In comparison, the minimum factor of safety met design requirements at 1. The mass was lessened to 0.348 kg, representing a 49.2% decrease in comparison with pre-optimization levels. The 3D-printed bracket was fabricated by employing a 3D printer, thereby achieving the aforementioned mass abatement. The battery pack parts exhibited a bright surface with low roughness and no discernible warping or deformation defects. As revealed by the assembly results, the components of the battery pack bracket are tightly coordinated with each other, with no evident assembly conflicts, revealing that the dimensional accuracy and fit of the completed parts meet production requirements. These findings lay solid groundwork for the mass production of high-performance battery pack brackets.