Influence of the Aggregate-Pouring Sequence on the Efficiency of Plugging Inundated Tunnels through Drilling Ground Boreholes

Abstract

This paper presents an experimental and field investigation on the efficiency of plugging by pouring aggregate in different sequences through multiple boreholes in a tunnel with flowing water. There have been controversies surrounding the selection of the pouring order for different particle sizes of aggregates and the order in different boreholes. A visualized experimental setup is used to investigate the influence of the pouring orders on the efficiency of plugging through multiple boreholes under the flowing-water condition. A case study of the salvage of a flooded mine using ground directional boreholes was investigated and compared with the experimental results. The water-pressure difference at the aggregate-capping moment, when fine aggregate was poured first and coarse aggregate later, was relatively small, compared to that when fine aggregate was poured upstream and coarse aggregate, downstream. The result implies that the efficiency of plugging with the order of pouring fine aggregate first and coarse aggregate later in different boreholes is better than that with the order of pouring fine aggregate upstream and coarse aggregate downstream. When the poured aggregate is about to be capped, increasing the pouring intensity with the same or a larger particle size is more conducive to capping. The case study shows that pouring fine materials in the early stage reduced the cross-sectional area; in the later stage, the aggregate particle size was gradually increased, which can be helpful in forming an effective water-barrier section in the tunnel. The pouring of aggregate provided a base for cement grouting to form a water-plug section with a length of 106 m, resulting in a sealing efficiency of 100% for the case.