Affiliation:
1. Division of Metrology and Measurement Systems, Institute of Mechanical Technology, Faculty of Mechanical Engineering, Poznan University of Technology, 5 M. Skłodowska-Curie Square, 60-965 Poznan, Poland
Abstract
In this paper, the multiscale analysis of the reproduction accuracy of jaw geometry obtained via the use of selected orthodontic materials is discussed. Impressions were made from two types of impression material. An accuracy assessment of the model geometry mapping was performed using noncontact systems, including a fringe projection optical 3D scanner, computed tomography, and a focus variation microscope. Measurements were made in three modes for comparison, as were the silicone and polyether impression materials. These modes were a jaw model and impression, an impression and plaster model, and plaster and jaw models. The research results are presented as colorful maps of deviations. Data analysis showed that deviations were the smallest in the case of silicone and that the best fit occurred between the silicone impression and the plaster model. The conducted research confirmed the validity of the assumptions considering the use of multiscale analysis for geometric analysis. The use of modern multiscale measurement methods allows for shorter and more efficient prosthetic operations. At present, these devices are expensive and complicated to use, but developments in technology should simplify the process, and prosthetic professionals should be aware of the possibilities described in the paper.
Funder
Ministry of Education and Science in Poland
Subject
Fluid Flow and Transfer Processes,Computer Science Applications,Process Chemistry and Technology,General Engineering,Instrumentation,General Materials Science
Reference58 articles.
1. Optical 3D scans for orthodontic diagnostics performed on full-arch impressions. Completeness of surface structure representation;Vogel;J. Orofac. Orthop.,2015
2. Improvement and Application of Mass Spring Model in Simulation of Gingi-val Soft Tissue Deformation;Ma;J. Comput.-Aided Des. Comput. Graph.,2020
3. Palczewska-Komsa, M.O., Gapiński, B., and Nowicka, A. (2022). The Influence of New Bioactive Materials on Pulp-Dentin Complex Regeneration in the Assessment of Cone Bone Computed Tomography (CBCT) and Computed Micro-Tomography (Micro-CT) from a Present and Future Perspective—A Systematic Review. J. Clin. Med., 11.
4. Dobrzanski, L.A., and Dobrzanski, L.B. (2020). Dentistry 4.0 Concept in the Design and Manufacturing of Prosthetic Dental Restorations. Processes, 8.
5. The Evolution of Dental Materials for Hybrid Prosthesis;Gonzalez;Open Dent. J.,2014
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献