Production and Application of Biosurfactant Produced by Bacillus licheniformis Ali5 in Enhanced Oil Recovery and Motor Oil Removal from Contaminated Sand

Abstract

The present study describes the production of biosurfactant from isolate B. licheniformis Ali5. Seven different, previously-reported minimal media were screened for biosurfactant production, and two selected media were further optimized for carbon source. Further, various fermentation conditions such as (pH 2–12, temperature 20–50 °C, agitation speed 100–300 rpm, NaCl (0–30 g·L−1) were investigated. The partially purified biosurfactant was characterized by Fourier transform infrared spectroscopy (FTIR) and matrix-assisted laser desorption/ionization time-of-flight mass spectroscopy (MALDI-TOF MS) and found a lipopeptide mixture, similar to lichenysin-A. Biosurfactant reduced surface tension from 72.0 to 26.21 ± 0.3 and interfacial tension by 0.26 ± 0.1 mN·m−1 respectively, biosurfactant yield under optimized conditions was 1 g·L−1, with critical micelle concentration (CMC) of 21 mg·L−1 with high emulsification activity of (E24) 66.4 ± 1.4% against crude oil. Biosurfactant was found to be stable over extreme conditions. It also altered the wettability of hydrophobic surface by changing the contact angle from 49.76° to 16.97°. Biosurfactant efficiently removed (70-79%) motor oil from sand, with an efficiency of more than 2 fold as compared without biosurfactant (36–38%). It gave 32% additional oil recovery over residual oil saturation upon application to a sand-packed column. These results are indicative of potential application of biosurfactant in wettability alteration and ex-situ microbial enhanced oil recovery.