Affiliation:
1. Department of Mechanical and Materials Engineering, Queen’s University, Kingston, ON K7L3N6, Canada
Abstract
Unsteady separation is a phenomenon that occurs in many flows and results in increased drag, decreased lift, noise emission, and loss of efficiency or failure in flow devices. Turbulence models for the steady or unsteady Reynolds-averaged Navier–Stokes equations (RANS and URANS, respectively) are commonly used in industry; however, their performance is often unsatisfactory. The comparison of RANS results with experimental data does not clearly isolate the modeling errors, since differences with the data may be due to a combination of modeling and numerical errors, and also to possible differences in the boundary conditions. In the present study, we use high-fidelity large-eddy simulation (LES) results to carry out a consistent evaluation of the turbulence models. By using the same numerical scheme and boundary conditions as the LES, and a grid on which grid convergence was achieved, we can isolate modeling errors. The calculations (both LES and RANS) are carried out using a well-validated, second-order-accurate code. Separation is generated by imposing a freestream velocity distribution, that is modulated in time. We examined three frequencies (a rapid, flutter-like oscillation, an intermediate one in which the forcing and the flow have the same timescales, and a quasi-steady one). We also considered three different pressure distributions, one with alternating favorable and adverse pressure gradients (FPGs and APGs, respectively), one oscillating between an APG and a zero-pressure gradient (ZPG), and one with an oscillating APG. All turbulence models capture the general features of this complex unsteady flow as well or better than in similar steady cases. The presence, during the cycle, of times in which the freestream pressure-gradient is close to zero affects significantly the model performance. Comparing our results with those in the literature indicates that numerical errors due to the type of discretization and the grid resolution are as significant as those due to the turbulence model.
Funder
Natural Science and Engineering Research Council of Canada
CRD
Subject
Fluid Flow and Transfer Processes,Mechanical Engineering,Condensed Matter Physics
Reference45 articles.
1. Review—A Review of Some Phenomena in Turbulent Flow Separation;Simpson;J. Fluids Eng.,1981
2. A study of turbulent boundary-layer separation and reattachment;Perry;J. Fluid Mech.,1975
3. Patrick, W.P. (1987). Flowfield Measurements in a Separated and Reattached Flat Plate Turbulent Boundary Layer. Final Report, National Aeronautics and Space Administration. NASA contractor report NASA-CR-4052.
4. Turbulent Boundary-Layer Separation;Simpson;Annu. Rev. Fluid Mech.,1989
5. Direct numerical simulation of a separated turbulent boundary layer;Na;J. Fluid Mech.,1998
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献