Effect of Pulsed-Plasma Treatment on the Structural-Phase Composition and Tribological Properties of Detonation Coatings Based on Ti–Si–C

Abstract

The structural-phase state and tribological characteristics of detonation coatings based on Ti–Si–C before and after pulsed-plasma exposure have been experimentally investigated. The authors of the research used a detonation set-up of CCDS2000 to obtain coatings. The modification of coating surfaces was carried out by a pulsed-plasma flow using the “Impulse-6” installation. The results of the research have shown that the modification of coatings surface by a pulsed-plasma effect causes an increase in the microhardness of the surface layer and in its wear resistance. It was determined that after such type of treatment, there is an increase in the content of the Ti3SiC2 phase. According to the results of XRD analysis, the improvement in the mechano-tribological properties of detonation spraying coatings of the Ti–Si–C system as a result of pulsed-plasma treatment is associated with an increase in the content of Ti3SiC2 phases in the coatings, as well as the formation of carbide and oxide phases on the surface layer.