Effects of Electrical Parameters on Micro-Arc Oxidation Coatings on Pure Titanium

Abstract

The micro-arc oxidation process was used to apply a ceramic oxide coating on a pure titanium substrate using calcium acetate and sodium dihydrogen phosphate as an electrolyte. The influence of the current frequency and duty ratio on the surface morphology, phase composition, wear behavior, and corrosion resistance were analyzed by employing a scanning electron microscope, X-ray diffractometer, ball-on-disk apparatus, and potentiodynamic polarization, respectively. Analyses of the surface and cross-sectional morphologies revealed that the MAO films prepared via a low current frequency (100 Hz) and a high duty ratio (60%) had a lower porosity and were more compact. The medium (500 Hz) and high (1000 Hz) frequencies at the higher duty ratios presented with better wear resistance. The highest film thickness (11.25 µm) was achieved at 100 Hz and a 20% duty ratio. A negligible current density was observed when the frequency was fixed at 500 Hz and 1000 Hz and the duty cycle was 20%.