Influence of Laser Scanning Speed on Wear and Corrosion Resistance of Aluminum–Nickel Coating on Magnesium Alloy-Reference-Cited by-同舟云学术

Influence of Laser Scanning Speed on Wear and Corrosion Resistance of Aluminum–Nickel Coating on Magnesium Alloy

Published:2024-08-13 Issue:8 Volume:12 Page:1689
ISSN:2227-9717
Container-title:Processes
language:en
Short-container-title:Processes

Author:

Gao Yali¹^ORCID,Jiang Shan¹,Lu Pengyong¹,Bai Sicheng¹,Zhang Dongdong¹,Jie Meng²

Affiliation:

1. Department of Mechanical Engineering, Northeast Electric Power University, No. 169 Changchun Road, Jilin 132012, China

2. School of Mechanical Electrical Engineering, Jilin Institute of Chemical Technology, Jilin 132022, China

Abstract

To improve the wear and corrosion resistance, Al-Ni coating was prepared on Mg alloy by laser cladding, and the influence of the laser scanning speed on the microstructure, wear and corrosion resistance of the coatings was systematically analyzed. The results showed that the coatings with different scanning speeds were composed of Al3Ni2, Mg17Al12 and Mg2Al3 phases. The coatings presented fine needle-like grains. Under different scanning speeds, the microhardness of the coatings was 3.3–4.8 times that of the substrate, and the wear volume of the coatings was decreased by 40.08–51.38%. The coating with a laser scanning speed of 600 mm/min had the highest hardness, the best wear and corrosion resistance.

Funder

Science and Technology research of the Department of Education of Jilin Province

Natural Science Foundation of the Science and Technology Department of Jilin Province

Publisher

MDPI AG

Link

https://www.mdpi.com/2227-9717/12/8/1689/pdf

Reference35 articles.

1. Solidification behavior and morphological evolution in laser surface forming of AlCoCrCuFeNi multi-layer high-entropy alloy coatings on AZ91D;Meng;J. Alloys Compd.,2019

2. Effects of ultrasonic treatment on the microstructures and hardening of Al–Cu–Mg–Ag alloys;Mao;J. Mater. Res. Technol.,2024

3. Grain refinement and strength enhancement in Mg wrought alloys: A review;Wang;J. Magnes. Alloy.,2023

4. In-situ TiC-Al3Ti reinforced Al-Mg composites with Y2O3 addition formed by laser cladding on AZ91D;Yang;Surf. Coat. Technol.,2020

5. A gradient Al/Ni-Cr-Al layer formed by direct current pulse metal inert gas welding combined laser cladding on AZ91D magnesium alloy;Pei;Vacuum,2019