Design and Manufacture of Millimeter-Scale 3D Transformers for RF-IC

Abstract

The development of radio-frequency integrated circuits (RF-IC) necessitates higher requirements for the size of microtransformers. This paper describes millimeter-scale 3D transformers in millimeter-scale, solenoidal, and toroidal transformers manufactured using Micro-electromechanical Systems (MEMS). Two through-silicon via (TSV) copper coils with a high aspect ratio are precisely interleaved on a reserved air core (magnet core cavity) with a vertical height of over 1 mm because of the thickness of the substrate, which increases the performance while reducing the footprint. The effects of the wire width, coil turns, magnetic core, and substrate on the performance of the two transformers are discussed through numerical simulations. When an air core is present, solenoidal transformers are better than toroidal transformers in terms of performance and footprint; however, the gap decreases when the size is reduced. Additionally, the magnetic core significantly improves the performance of the toroidal transformer compared to that of the solenoid. Thus, the toroidal transformer has a higher potential for further size reduction. The two types of transformers were then manufactured completely using MEMS and electroplating. This paper discusses the influence of various parameters on millimeter-scale 3D transformers and realizes processing in silicon, which provides the foundation for integrating transformers in a chip.