Effect of Thermo-Mechanical Treatment on the Microstructure Evaluation and Mechanical Properties of Fe-20Mn-12Cr-3Ni-3Si Damping Alloy

Abstract

This study was carried out to investigate the effect of thermo-mechanical treatment on the microstructure of Fe-20Mn-12Cr-3Ni-3Si damping alloy. Dislocation, αʹ, and ε-martensite were formed by thermo-mechanical treatment. The intersections of the surface relief and specific direction due to martensitic transformation were generated by thermo-mechanical treatment. They were then reversed to austenite with an ultra-fine grain size of less than 5 μm by annealing treatment at 700°C for 20min. The volume fractions of dislocation, αʹ, and ε-martensite were increased with the cycle number of thermo-mechanical treatment. In five-cycle number thermo-mechanical treated specimens, more than 45% of the volume fraction of ε-martensite and less than 3% of the volume fraction of α΄-martensite were attained. Therefore, in this article, the effect of thermo-mechanical treatment is briefly introduced, and these phenomena are explained in terms of the grain refinement of austenite, αʹ, and ε-martensite distribution and homogeneous dislocation distribution.