Affiliation:
1. Advanced Materials Laboratory Sandia National Laboratories Albuquerque New Mexico USA
2. Center for MicroEngineered Materials University of New Mexico Albuquerque New Mexico USA
Abstract
AbstractThe coating and drying of inks and slurries are important steps to manufacture a plethora of products. Drying processes, particularly, comprise energy‐intensive steps that affect product cost and quality. Prior work has highlighted failures of various multicomponent diffusivity models to conserve mass in dryer modeling and challenges in predicting process limits given variability in published values of key thermodynamic parameters. Herein, we develop a computational model and benchtop drying experiments to investigate these concerns for drying polymer‐laden coatings. Model predictions of process limits in a single‐zone drying oven demonstrate that published variability in Flory–Huggins parameter yields large variations in predicted operating temperatures above which blistering occurs. This indicates that caution should be exercised when choosing approaches to obtain or predict the Flory–Huggins parameter, and that both benchtop drying experiments and a set of additional experiments, such as sorption experiments, are needed to fully characterize and optimize a given drying process.
Funder
U.S. Department of Energy
Subject
General Chemical Engineering,Environmental Engineering,Biotechnology