Experimental study on the damage characteristics of cyclic disturbance and acoustic emission characteristics of different types of sandstones under high stress in deep mines

Abstract

AbstractThree sandstone specimens common in rock engineering were selected to study the differences in the mechanical properties of rocks with different lithologies. The development and expansion of the internal cracks in the specimens were observed by combining the simulation system with the acoustic emission system. Through the combination of dynamic and static stresses, the deformation and damage of rocks under deep rock excavation and blasting were simulated. As the results show, the acoustic emission events of specimens with different lithologies under combined static and dynamic cyclic loading can be roughly divided into three phases: weakening, stabilizing, and surging periods. In addition, the acoustic emission characteristics of specimens with different lithologies show general consistency in different compression phases. The degree of fragmentation of specimens increases with the applied stress level; therefore, the stress level is one of the important factors influencing the damage pattern of specimens. The acoustic emission system was used to simulate the deformation and damage of rocks subjected to deep rock body excavation and engineering blasting. Cyclic dynamic perturbations under sinusoidal waves with a frequency of 5 Hz, a loading rate of 0.1 mm/min, a cyclic amplitude of 5 MPa, and a loading rate of 0.1 mm/min were applied to the three rock samples during the experiments. Among them, the fine‐grained sandstones are the most sensitive to the sinusoidal cyclic perturbation, followed by the muddy siltstone and the medium‐grained sandstones. On this basis, the acoustic emission energy release characteristics were analyzed, and the waveform characteristics in the damage evolution of the specimen under dynamic perturbation were studied by extracting the key points and searching for the main frequency eigenvalues.